Specifications: Application Fields: R/C cars & R/C boats Battery range: LI-XX = 2 ~ 4 cells; 7.2V ~ 14.4V NI-XX = 5 ~ 12 cells; 6.0V ~ 14.4 V Working Current: 75A /80A Surge 15S PWM frequency: 8 KHz Maximum RPM: 2-pole motor / 210,000 rpm 6-pole motor / 70,000 rpm 12-pole motor / 35,000 rpm Protection: OVP, Over Voltage (battery) Protection LVP, Low Voltage Protection (soft cutoff) Startup protection Auto cutoff when the motor silts up OHP, Over Heat protection BEC Current: 3A（Max.） Weigh: 55 g Size: 70 x 27 x 19 (mm)
Features: ●Great for small and multifunctional, easy to operate. ●Fast speed up when the motor starting， and can use on all the model. ●Over voltage protection and low voltage protection. When the voltage is higher or lower than the default, the throttle range limited within 30% of the full speed. ●Startup protection, limit current to prevent damage to ESC. ●Throttle adjust automatically, it’s universal for the entire transmitter. ●Brake type setting. ●Swap two of the three motor wires can change the direction of the model. ●Auto shut down when signal is lost or radio interference becomes severe within 2 seconds. ●Auto cutoff when the motor silts up to prevent the damage to motor and ESC. ●Over heat protection, ●User easily Programmable ESC Features by our ESC Programming Card. ●ESC can make brushless motor play music when all the setting is ready to go.
Operation Produce: ●Installation of ESC A. Plug in the 3 motor wires to the 3 wires on the ESC and then mount ESC and motor in the car. B. Plug in the Rx in ESC lead to CH2 on your receiver. C.Make sure the ESC’ s switch is off, solder the high quality battery connect to the ESC. D.Holding full throttle on your transmitter, turn the switch,, after 2 seconds, you’ll hear two ”Beep” from the motor, then move the stick to the low end, after one second, you’ll hear one “beep” from motor. Now the setting is ready, switch up the throttle stick to start. ATTENTION: It can skip the throttle range setting when needn’t adjustment for use next time, move the stick to the neutral, power on and move the stick to start ESC
●Throttle Range Setting: A. Switch on the transmitter and move the throttle stick to the top end, then connect battery to the ESC. B. After two seconds, two short “beep” will be heard from the motor, then move the throttle stick to neutral point, one short “beep” will be heart from the motor after one second, now the setting is ready a melody will be heard. Adjust the throttle stick to start flight. C. Throttle adjustment error: when the throttle range is too narrow or improper use, the ESC can’t receive the throttle range and fifteen short “beep” will be heard from the motor. D. When the throttle stick is neither up the neutral point nor below the end point, will the motor ring rapidly in a row. Move the stick to neutral to resume.
●Program card setting: Must use “ESC PROGRAMMNG CARD PRO” version to set ESC (For more details please read the programming card instruction)